Regal V6-3.8L VIN K (1997)
Brake Shoe: Service and Repair
Shoes and Linings
^
Tool Required:
-
J 38400 Brake Shoe Spanner and Spring Remover
CAUTION: Keep fingers away from rear brake shoe springs to prevent fingers from being pinched between spring and shoe web or spring and
backing plate.
NOTICE: Do not pry against the splash shield or backing plate in attempt to free the drum. This will bend the splash shield or backing plate. A bent
backing plate may cause brake chatter and/or pulsation.
NOTICE: Do not over stretch the Adjuster spring. Damage can occur if the spring is over stretched.
REMOVE OR DISCONNECT
1. Raise vehicle and suitably support.
2. Mark relationship of wheel to axle flange.
3. Tire and wheel.
4. Mark relationship of drum to axle flange.
5. Brake drum.
-
If difficulty is encountered in removing drum the following steps may be of assistance:
