Regal V6-3.8L VIN K (1997)
^11GTighten traction control module bolt to bracket to 3 Nm (27 inch lbs.).
8. Inspect brake fluid level.
a. Remove brake fluid reservoir cover.
b. Inspect brake fluid level in reservoir and fill to correct level if necessary.
c. Replace brake fluid reservoir cover.
9. Raise vehicle and suitably support.
10. Flush wheel brakes using the following sequence.
Right rear > Left rear > Right front > Left front.
a. Attach bleeder hose to bleeder valve at each wheel and place the other end into a container to collect draining brake fluid. Do not submerge
hose end in fluid.
b. Slowly open bleeder valve and allow fluid to flow.
c. Close valve when clean brake fluid begins to flow or at least 235 ml (8 ounces) of fluid is accumulated.
11. Flush right rear wheel brake using sequence in Step 10.
12. Flush left front wheel brake using sequence in Step 10.
13. Flush left rear wheel brake using sequence in Step 10.
14. Flush right front wheel brake using sequence in Step 10.
^
Tighten bleeder valves:
-
Front Caliper to 13 Nm (115 inch lbs.).
-
Rear Caliper to 7 Nm (62 inch lbs.).
-
Rear Wheel Cylinder to 7 Nm (62 inch lbs.).
NOTE: Be sure the bleeder valves do not leak.
15. Lower vehicle.
16. Replace all rubber components.
17. Repeat flushing procedure one more time.
18. Inspect brake fluid level in reservoir and fill to correct level if necessary.Replace brake fluid reservoir cap.
19. Bleed the entire brake hydraulic system.
