Regal V6-3.8L VIN K (1997)
4. Bolt boots and bushings from bracket.
Inspect
-
Bracket for cracks. Replace if necessary.
INSTALL OR CONNECT
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
the manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Lubricated new bolt boots and bushings with silicone grease.
2. Bolt boots and bushings into caliper bracket.
3. Caliper bracket with bracket bolts.
-
Tighten caliper bracket bolts to 185 Nm (137 ft. lbs.).
4. Caliper. Refer to "CALIPER."
