Regal V6-3.8L VIN K (1997)
Vacuum Brake Booster: Service and Repair
^
Tool Required:
-
J 22805-01 Power Brake Booster Holder
CAUTION: When replacing the power brake booster, make sure that the cruise control cable is not routed between the booster and the cowl.
If the cable is damaged or pinched, it must be replaced. Failure to do this could result in personal injury.
NOTICE: Inspect locking flanges on brake booster and mounting plate. Replace the brake booster and mounting plate if the locking flanges are bent or
damaged.
REMOVE OR DISCONNECT
1. Engine acoustic cover.
2. ABS hydraulic modulator/master cylinder.
3. Transmission fluid filler tube.
4. EGR heat shield.
5. Vacuum hose from brake booster.
NOTICE: When disconnecting the pushrod from brake pedal, the brake pedal must be held stationary or damage to the brake switch may result.
NOTICE: Do not attempt to remove booster until pushrod is disconnected from the brake pedal.
6. Brake booster pushrod from brake pedal.
7. Attach J 22805-01 to brake booster with nuts.
-
Tighten nuts to 27 Nm (20 ft. lbs.).
