buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

33-17-01A|Page 4431 > < Heat Shield, Exhaust|Service and Repair
Page 1
background image

Muffler: Customer Interest
Exhaust System - Paint Peeling from Painted Muffler

File In Section: 10 - Body 

Bulletin No.: 33-17-01A

Date: December, 1997

Subject: 
Paint Peeling from Muffler 
(New Repair Paint Available)

Models: 
1993-98 Passenger Cars with Painted Mufflers

This bulletin is being revised to add additional model years. Please discard Corporate Bulletin Number 33-17-01 (Section 10 - Body).

Condition

Some owners may experience paint peeling from the muffler.

Correction

Clean and repaint the affected area using the following procedure and product.

Important

DO NOT REPLACE COMPONENTS TO REPAIR THIS CONDITION.

The exhaust system must be cold to begin this procedure.

Material Required: * Wabash Products # KB-318-HHHS, available in pints or quarts as ready to spray material (no mixing required). Call Wabash
Products, 1-800-326-7269 or 812-232-6097 for pricing and shipping information.

Procedure

On a cold exhaust system:

1.

Raise vehicle on hoist.

2.

While supporting exhaust with a transmission jack, remove the rear exhaust system hangers and lower the exhaust.

3.

Clean the affected area with a wax and grease remover, lacquer thinner or other suitable solvent.

4.

Wire brush the affected area to remove flaking paint and blow off with air.

5.

Sand the affected area with # 80 to 150 grit sandpaper to remove rust, dirt or other contaminants.

6.

Clean the affected area with a wax and grease remover, lacquer thinner or other suitable solvent.

7.

Tape off the rear lower body panels and exhaust pipes forward of mufflers to protect from overspray.

8.

Apply paint to affected area in several (6 to 8) thin coats (to prevent sags and runs) obtaining approximately 1 mil paint coverage.

9.

Raise exhaust system with jack, reinstall exhaust hangers, lower vehicle and remove from hoist.

^

Allow 30 minutes drying time.

10.

In a well ventilated area, start engine and allow to idle for up to 30 minutes until paint is cured and dry.

Important

Some "smoking" will occur while curing the paint with the engine running.

The paint can be heated and cured while driving, but be careful not to get the exhaust system wet during the first 30 minutes.

Warranty Information

33-17-01A|Page 4431 > < Heat Shield, Exhaust|Service and Repair