Regal V6-3.8L VIN K (1997)
inserted into the coupling before shaft installation, the two mating shafts may disengage.
NOTICE: Set steering shaft so block tooth on upper steering shaft is at the 12 o'clock position, wheels on vehicle are straight ahead and set
ignition switch to "LOCK" position. Failure to follow these procedures could result in damage to the SIR coil.
11. Position plastic cover and intermediate steering shaft lower bolt.
12. New rear frame bolts/screws.
13. Lower vehicle.
14. Reservoir inlet hose to pump.
^
Tighten reservoir inlet hose fitting to 27 Nm (20 ft. lbs.).
15. Tie straps to hose.
16. Engine mount strut at engine.
17. Fill power steering pump reservoir with fluid.
18. Bleed system.
^
Inspect for leaks.
