Regal V6-3.8L VIN K (1997)
Wheel Cover: Service and Repair
REMOVE OR DISCONNECT
1. Tire and wheel.
2. Place a block of wood approximately 50 mm (2 inches) diameter with a squared off end against the back surface of the cap. A sharp hammer blow
on the block of wood will remove the cap.
INSTALL OR CONNECT
NOTICE: Failure to hit cap squarely without the load distributed evenly could result in permanent damage to the cap.
1. Place cap into position at wheel opening and place a block of wood at least 76 mm (3 inches) in diameter against cap face. Install cap by striking
block of wood with hammer.
2. Tire and wheel.
