Regal V6-3.8L VIN K (1997)
8. Cap the in-pipe fuel filter pipe, the fuel feed pipe, and the fuel return pipe as needed to stop any fuel leakage.
9. Remove the fuel feed, fuel return, and EVAP pipe attaching hardware and the fuel feed, fuel return, and EVAP pipes.
10. Note the position of the fuel and EVAP pipes and the fuel and EVAP pipe attaching hardware for installation.
11. Inspect the pipes for bends, kinks and cracks.
12. Repair or replace the pipe or pipes as required.
INSTALLATION PROCEDURE
1. Install the new fuel feed, fuel return, and EVAP pipes and the fuel and EVAP pipe attaching hardware as noted during removal.
2. Remove the caps from the in-pipe fuel filter pipe, the fuel feed pipe, and the fuel return pipe.
3. Install the fuel return pipe quick-connect fitting in front of the fuel tank.
4. Install the fuel feed pipe threaded fitting at the outlet of the in pipe fuel filter.
-
Tighten The in-pipe fuel filter fitting to 30 Nm (22 lb ft).
5. Lower the vehicle.
6. Install the fuel feed (1), and fuel return pipe (2) quick-connect fittings in the engine compartment.
7. Add fuel and install the fuel tank filler pipe cap.
8. Tighten the fuel tank filler pipe cap.
9. Install the negative battery cable. Inspect for leaks.
-
Turn the ignition switch to the ON position for two seconds.
-
Turn the ignition switch to the OFF for ten seconds.
-
Turn the ignition switch to the ON position again.
-
Check for fuel leaks.
