Regal V6-3.8L VIN K (1997)
INSTALLATION PROCEDURE
Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel flow. Also,
assure that the fuel pump strainer does not block full travel of float arm.
Be sure that the fuel sender assembly retaining snap ring is fully seated within the tab slots on the fuel tank.
1. Position the new fuel sender assembly O-ring on the fuel tank.
2. Install the fuel sender assembly into the fuel tank.
3. Install the fuel sender assembly retaining snap ring.
4. Install the fuel sender electrical connector.
5. Install the quick-connect fittings at the fuel sender assembly.
6. Install the negative battery cable.
7. Install the fuel filler cap.
8. Inspect for leaks.
A. Turn the ignition switch to the ON position for 2 seconds.
B. Turn the ignition switch to the OFF for 10 seconds.
C. Turn the ignition switch to the ON position again.
D. Check for fuel leaks.
9. Install the fuel sender access panel.
10. Install the (7) nuts retaining the fuel sender access panel.
Tighten
Access panel nuts to 10 Nm (8 lb ft).
11. Install the trunk liner.
12. Install the spare tire, the jack, and the spare tire cover.
