Regal V6-3.8L VIN K (1997)
Manifold Pressure/Vacuum Sensor: Technical Service Bulletins
Manifold Absolute Pressure Sensor (VIN K)
The Manifold Absolute Pressure (MAP) sensor responds to changes in intake manifold pressure. The PCM supplies a 5 volt reference and a ground for
the MAP sensor. The MAP sensor provides a signal to the PCM relative to pressure changes in the manifold. The MAP sensor signal voltage to the PCM
varies from below 2 volts at idle (low manifold absolute pressure - high vacuum) to above 4 volts with the key ON, engine not running or at wide-open
throttle (high manifold absolute pressure - low vacuum). The PCM monitors the MAP signals for voltages outside the normal range of the MAP sensor.
If the PCM detects a voltage that is lower than the possible range of the MAP sensor, DTC PO1O7 will be set. A signal voltage that is higher than the
possible range of the sensor will set DTC P0108. An intermittent low or high voltage will set DTC P1107 or P1105 respectively.