Regal V6-3.8L VIN K (1997)
18.
Install both outer tie rod ends to the steering knuckles. On models with torque prevailing nuts, tighten the nut to 30 Nm (22 lb ft) and then tighten
an additional 115 degrees. On models with a slotted nut and cotter pin, tighten the nut to 85 Nm (63 lb ft). If necessary, tighten the nut slightly in
order to insert the cotter pin through the tie rod stud. Bend the cotter pin ends against the flats of the nuts.
19.
Partially raise the rear of the engine cradle.
20.
Connect the intermediate steering shaft to the steering gear and install the bolt.
Tighten
Tighten to 48 Nm (35 lb ft).
21.
Raise the rear of the engine cradle and install the rear attaching bolts.
Tighten
Tighten to 180 Nm (133 lb ft).
22.
Install both front tire and wheel assemblies.
Tighten
Tighten the wheel nuts to 140 Nm (103 lb ft).
23.
Lower the vehicle.
24.
Add power steering fluid and bleed the system.
25.
Check the alignment and set toe-in as necessary.
26.
Close the hood.
