Regal V6-3.8L VIN K (1997)
1. Position the regulator to the door.
2. Install the electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: In order to ensure proper orientation of the window regulator to the door, tighten the window regulator bolts in the specified
sequence (1,2,3,4).
3. Install the regulator mounting bolts.
Tighten
Tighten the window regulator bolts to 10 Nm (89 lb in).
4. Remove the tape.
5. Lower the window far enough in order to gain access through the door inner panel to the bolts.
6. Install the window to regulator bolts (2).
