Regal V6-3.8L VIN K (1997)
Labor
Labor
Operation
Description
Time
N3595
Windshield Wiper Motor
0.4 hr
Crank Arm Assembly
For Drilling Hole in Wiper
Add
Motor Bracket and
0.1 hr.
Installing New Wiper
Motor Water Deflector
Deflector, Windshield
Wiper Motor Water -
N3598
Install/Replace (Labor
0.3 hr.
time includes for drilling
hole in wiper motor
bracket as necessary)
Service Procedure
1.
Turn ignition switch to the "Accessory" position.
2.
Set wiper switch to the maximum "Delay" position.
3.
Wait for the wiper arms to cycle once and stop in the "Pause" or "Innerwiper" position.
4.
Turn the ignition switch to the "Off" position when the wiper arms are in the "Pause" or "Innerwiper" position and not moving.
Important:
Before disconnecting negative battery cable, record radio station pre-sets.
5.
Disconnect negative battery cable.
6.
Place a piece of masking tape on the windshield at the tip of both wiper blades. The tape will be used for determining correct wiper arm/blade
positioning during reinstallation.
7.
Disconnect washer hose from both wiper arms.
8.
Remove attaching nut from each wiper arm and remove arms using a standard battery cable puller.
9.
Remove rear hood to cowl seal.
10.
Disconnect washer hose from leaf screen and remove leaf screen.
^
On Buick and Oldsmobile models with a two-piece leaf screen, it is only necessary to remove the left (driver's) side.
^
On Pontiac models with a one-piece leaf screen, it is necessary to remove the complete leaf screen.
