Regal V6-3.8L VIN K (1997)
Description
Description
Remove or Disconnect
1. Wiper arm assemblies from wiper transmission assembly drive shafts.
2. Air inlet screen assembly from vehicle.
3. Connector (16) from wiper motor assembly (17).
4. Wiper transmission assembly (18) from wiper motor crank arm assembly (19) using tool J 39232.
5. Three screws (20) and wiper drive system module (21) from vehicle.
6. Wiper motor crank arm assembly (19) from wiper motor assembly (17).
A. Rubber boot (22) from wiper motor crank arm assembly (19).
B. Loosen screw (23).
C. Tap on screw (23) with a soft-faced mallet while holding up on wiper motor crank arm assembly (19) until wiper motor crank arm assembly
(19) is loose on wiper motor assembly (17).
D. Remove screw (23) and wiper motor crank arm assembly (19) from wiper motor assembly (17).
7. Three screws (24) and wiper motor assembly (17) from wiper drive system module (21).
8. Shaft seal (25) and water shield (26) from wiper motor assembly (17).
Install or Connect
NOTICE: Refer to Service Precautions.
1. Water shield (26) and shaft seal (95) on wiper motor assembly (17).
2. Wiper motor assembly (17) on wiper drive system module (21) with three screws (24).
Tighten
^
Screws to 7 N.m (62 lb. in.).
