Regal V6-3.8L VIN K (1997)
3. Wiper motor crank arm assembly (19) on wiper motor assembly (17).
A. Connector (16) to wiper motor assembly (17).
B. Turn ignition switch in "ACCY" position.
C. Set wiper switch to "PULSE" position. Wiper motor assembly (17) should be operating.
D. Turn off ignition switch when wiper motor assembly (17) is in the innerwipe position and not moving.
E. Disconnect connector (16) from wiper motor assembly (17).
NOTICE: Do not rotate wiper motor assembly shaft during installation of wiper motor crank arm assembly.
F. Install wiper motor crank arm assembly (19) on wiper motor assembly (17) while maintaining. a 4- 8 mm (0.157-0.314 in.) gap between wiper
motor crank arm assembly (19) and bracket tab (J).
G. Install screw (23).
H. Check gap between wiper motor crank arm assembly (19) and bracket tab (J). If gap is not 4 - 8 mm (0.157-0.314 in.), remove crank arm
assembly (19) and repeat installation step 3.
Tighten
^
Screw to 16 N.m (144 lb. in.).
J. Rubber boot (22) on wiper motor crank arm assembly
4. Wiper drive system module (21) on vehicle with three screws (20).
Tighten
^
Screws to 10 N.m (88 lb. in.)
5. Wiper transmission assembly (18) on wiper motor crank arm assembly (19) using tool J 39529.
6. Connector (16) on wiper motor assembly (17).
7. Air inlet screen assembly on vehicle.
8. Wiper arm assemblies on wiper transmission assembly drive shaft.
9. operate wipers and check for proper operation.
