Regal V6-3100 3.1L VIN M SFI (1996)
3. With the ABS hydraulic modulator upside down, and the gears facing you, rotate each ABS brake modulator gear counterclockwise until
movement stops. This procedure will position the pistons on the ABS brake modulator very close to the top of the modulator bore. This will
simplify the brake bleeding procedure.
4. Position the motor pack onto brake modulator, aligning the three motor pack gears with the modulator gears.
Important
^
Take care in handling the ABS motor pack. If dropped or damaged during handling, the ABS motor pack must be replaced.
5. Four motor pack to brake modulator Torx head screws.
Tighten
^
Torx head screws 4.5 Nm (40 inch lbs.).
6. Gear cover onto brake modulator with Torx head screws.
Tighten
^
Torx head screws 4 Nm (35 inch lbs.).
7. Brake Modulator to Master Cylinder assembly.
