Regal V6-3100 3.1L VIN M SFI (1996)
1. Apply sealant to the keyway of the balancer. Use sealant GM P/N 12345739 or equivalent.
2. Install the crankshaft balancer. Use the J29113.
3. Remove the J29113.
4. Install the crankshaft balancer washer and the bolt.
^
Tighten the crankshaft balancer bolt to 103 Nm (76 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the right engine splash shield.
6. Install the right front tire and wheel.
7. Lower the vehicle.
8. Install the serpentine drive belt.
