Regal V6-3100 3.1L VIN M SFI (1996)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement (7X)
REMOVE OR DISCONNECT
1. Disconnect negative battery cable.
2. Crank steering wheel fully to the left.
3. Raise vehicle on hoist.
4. Sensor electrical connector.
5. Sensor to block bolt (1).
6. Sensor from engine.
7. Inspect the sensor for wear, cracks, or leakage.
-
Replace O-ring if necessary.
INSTALL OR CONNECT
1. Install the sensor to the block.
-
Lubricate O-ring with clean engine oil.
2. Install the bolt to hold sensor to block face.
Tighten
Bolt to 8 Nm (71 lb in.).
3. Connect the electrical connector.
4. Lower the vehicle.
5. Connect the negative battery cable.
