Regal V6-3100 3.1L VIN M SFI (1996)
Alignment: Specifications
Vehicle Ride (Trim) Height Specifications
Fig. 2 Ride Height Measurement Location
Fig. 11 Ride Height Specification Chart
1. Ensure vehicle is on level ground.
2. Ensure tires are inflated to proper pressures.
3. Fuel tank should be full to obtain accurate readings.
4. Trunk should be empty except for spare tire and jack.
5. Bounce car three times at front and rear to normalize suspension.
6. Measure from lowest point on the ball joint housing to control arm bolt centerline "D" and "K" positions), Fig. 2 .
7. Measure from level floor to rocker panel at "Z" and "J" positions.
8. Refer to for ride height measurement location and Fig. 11 for specification charts.
