Regal V6-3100 3.1L VIN M SFI (1996)
Tighten to 27 Nm (20 lb ft).
21.
Install the tie rod ends to the steering knuckles. Install the retaining nuts.
Tighten
Tighten to 30 Nm (22 lb ft), plus 120 degrees (or 2 flats of the nut).
22.
Raise the rear of the engine cradle and install the two rear attaching bolts.
Tighten
Tighten to 180 Nm (133 lb ft).
23.
Install the intermediate steering shaft to the steering gear and install the bolt.
Tighten
Tighten to 48 Nm (35 lb ft).
24.
Reposition the stabilizer bar.
25.
Install the left and right side stabilizer bar links to the lower control arms.
Tighten
Tighten to 23 Nm (17 lb ft).
26.
Install both wheel and tire assemblies. Install lug nuts.
Tighten
Tighten lug nuts to 140 Nm (103 lb ft).
27.
Lower the vehicle.
28.
Add power steering fluid and bleed the system.
29.
Check the alignment and set toe-in as necessary.