Regal V8-307 5.0L (1986)
Brake Bleeding: Service and Repair
Powermaster
CAUTION:Pressure bleeding equipment must be of the diaphragm type. It must have a rubber diaphragm between the air supply and the brake fluid to
prevent air, moisture arid other contaminants from entering the hydraulic system.
1. Fill the master cylinder section of reservoir approximately half full with new brake fluid. See fluid specified on reservoir cover.
2. Install the special bleeder adapter J-35360 on Powermaster.
3. Charge bleeder ball to 20-25 psi.
4. Connect line to adapter. Open line valve and depress bleed-off valve on top of adapter until a few drops of fluid appear.
5. Hoist car.
6. Attach bleeder hose to bleeder valve and submerge opposite end in clean container partially filled with brake fluid.
7. Open bleeder valve 1/2 to 3/4 turn and allow fluid to flow until no air is seen in fluid.
8. Bleeding sequence:
a. Right rear
b. Left rear
c. Right front
d. Left front
9. After bleeding, torque brake line connectors to 10-15 lb. ft.
