Regal Estate Wagon V6-252 4.1L VIN 4 4-BBL (1982)
13.
Assemble side cover on pitman shaft by screwing cover onto adjusting screw until cover bottoms on pitman shaft.
14.
Install pitman shaft so that center tooth in sector meshes with center groove of rack-piston. Make sure side cover O-ring is in place before pushing
side cover down on gear housing.
15.
Install side cover screws and lockwashers.
16.
Hold adjuster screw with Allen wrench and install new adjuster locknut halfway on adjuster screw.
17.
Install rack-piston end plug in rack-piston and tighten plug to 75-80 ft. lbs.
18.
Lubricate new housing end plug O-ring seal with power steering fluid and install in gear housing.
19.
Insert end plug into gear housing and seat against O-ring seal. Slight tapping with a mallet may be necessary to seat end plug properly.
20.
Snap end plug retainer ring into place with fingers. Slight tapping may be required to bottom ring in housing securely. Install coupling flange.
