Regal Estate Wagon V6-252 4.1L VIN 4 4-BBL (1982)
Steering Gear: Service and Repair
Refitting Rack-Piston Balls
Do not refit balls unless the steering is loose. If such is the case, a thrust adjustment and over-center adjustment should correct the problem if it lies in
the steering gear. If balls are pitted or rough, then select the proper ball size for proper adjustment.
If the torque reading obtained above is too high or too low (on new balls only), disassemble and reassemble, using the next size smaller (or larger)
balls and recheck worm preload.
A rack-piston nut with a ball size of 7 does not have a number stamped on the flat surface. For ball sizes other than 7, the ball size is stamped on the
flat surface of the rack-piston nut. Ball sizes are numbered from 6 to 11, with 6 being the smallest and 11 the largest. Ball sizes are graduated in
increments of .00008 inch from .28117 inch to .28157 inch.
