Rendezvous V6-3.5L (2007)
Important: Before installing the sunroof opening position switch, inspect the timing window. The small hole must be in line with the bar, as
shown. If the hole is not aligned with the bar, rotate the gear by hand left or right until the hole and the bar are in position.
2. Install the control module.
3. Install the motor/actuator.
4. Remove the pin that was installed to temporarily hold the position of the sunroof opening position switch.
Tighten the motor/actuator attachment screws to 3.5 N.m (31 lb in).
5. Connect the electrical connector to the motor/actuator.
6. Install the headliner.
Important: If the sunroof does not function properly, and the guides are parallel, then replace the sunroof opening switch.
7. Verify the operation of the sunroof.
