Rendezvous V6-3.5L (2007)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Replacement
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution.
Caution: For safety reasons, the Brake Pressure Modulator Valve (BPMV) must not be repaired; the complete unit must be replaced. With the
exception of the EBCM/EBTCM, no screws may be loosened. If screws are loosened, it will not be possible to get the brake circuits leak-tight
and personal injury may result.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.
1. Turn the ignition switch to the OFF position.
2. Remove the cruise control module mounting bolts, if equipped.
3. Position the cruise control module aside.
4. Remove the air cleaner assembly from the engine compartment.
5. Disconnect the electronic brake control module (EBCM) harness electrical connector (1).
6. Disconnect the EBCM to brake pressure modulator valve (BPMV) electrical connector.
Important: Note the locations of the brake pipes in order to aid in installation.
7. Disconnect the 4 wheel brake pipes from the BPMV.
Important: Cap the brake pipes to prevent brake fluid leakage and contamination.
