Rendezvous V6-3.5L (2007)
2. Place the fuel pressure gage bleed hose into an approved container and open the bleed valve in order to bleed off fuel system pressure.
3. Place a shop towel under the fuel pressure gage in order to catch any remaining fuel spillage.
4. Remove the fuel pressure gage from the fuel pressure service port.
5. Drain any fuel remaining in the fuel pressure gage into an approved container.
6. Inspect for leaks using the following procedure:
1. Turn the ignition ON, with the engine OFF for 2 seconds.
2. Turn the ignition OFF, for 10 seconds.
3. Turn the ignition ON, with the engine OFF for 2 seconds.
4. Turn the ignition OFF.
5. Inspect for fuel leaks.
7. Install the cap on the fuel pressure service port.
