Rendezvous V6-3.5L (2007)
Control Assembly: Service and Repair
HVAC - Manual
HVAC Control Module Replacement
Removal Procedure
1. Remove the I/P cluster trim plate bezel.
2. Remove the HVAC control module retaining screws.
3. Pull the HVAC control module straight out from the I/P.
4. Disconnect the HVAC control module electrical connector.
Installation Procedure
Important: The key should be in the off position when connecting the HVAC control module electrical connector to ensure proper
calibration.
1. Connect the HVAC control module electrical connector.
2. Install the HVAC control module into the I/P opening.
Notice: Refer to Fastener Notice.
3. Install the HVAC control module retaining screws.
