Rendezvous V6-3.5L (2007)
Installation Procedure
1. Lubricate the sensor O-ring with clean engine oil before installation and/or replace the O-ring, if necessary.
2. Install the CKP sensor.
Notice: Refer to Fastener Notice.
3. Install the CKP sensor stud.
Tighten the stud to 10 N.m (89 lb in).
4. Connect the engine harness electrical connector (2) to the CKP sensor.
5. Connect the coolant heater cord to the coolant heater, if equipped.
6. Position the catalytic converter. Refer to Exhaust Seal Replacement.
7. Lower the vehicle.
8. Perform the CKP system variation learn procedure.
