Rendezvous V6-3.5L (2007)
Important: Some lock rings were manufactured with "DO NOT REUSE" stamped into them. These lock rings may be reused if they are
not damaged or warped.
Important: Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock
ring.
Important: Check the lock ring for flatness.
8. Place the lock ring on a flat surface. Measure the clearance between the lock ring and the flat surface using a feeler gage at 7 points.
9. If warpage is less than 0.41 mm (0.016 in), the lock ring does not require replacement.
10. If warpage is greater than 0.41 mm (0.016 in), the lock ring must be replaced.
Installation Procedure
1. Install the fuel level sensor to the fuel sender module.
2. Clean the fuel sender sealing flange.
Important: Always replace the fuel sender seal when installing the fuel sender assembly. Replace the lock ring if necessary. DO NOT
apply any type of lubrication to the seal groove.
3. Install the NEW fuel sender seal (3) to the fuel tank seal groove.
4. Install the fuel sender (2) and the fuel sender lock ring (1).
