Rendezvous V6-3.5L (2007)
Fuel Pressure Release: Service and Repair
Fuel Pressure Gage Installation and Removal
Fuel Pressure Gage Installation and Removal
Tools Required
J 34730-1A Fuel Pressure Gage
Installation Procedure
Caution: Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or
diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.
Notice: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
* The fuel pipe connections
* The hose connections
* The areas surrounding the connections
1. Remove the intake manifold cover.
2. Remove the cap from the fuel pressure service port connection.
Caution: Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will
absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the
connection of the fuel pressure gage is complete.
3. Install the J 34730-1A to the fuel pressure service port located on the fuel rail. Wrap a shop towel around the fitting while connecting the gage to
avoid spillage.
4. Turn the ignition ON, with the engine OFF.
Caution: Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an
explosion.
5. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
6. Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
7. Command the fuel pump ON with a scan tool.
8. Close the bleed valve on the fuel pressure gage.
9. Inspect for fuel leaks.
Removal Procedure
1. Ensure the fuel pump is OFF.
