Rendezvous V6-3.5L (2007)
Ignition Cable: Service and Repair
Spark Plug Wire Replacement
Tools Required
J 41131 Engine Tilt Strap
Removal Procedure
Notice: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the
wire could be damaged.
1. Remove the intake manifold cover.
2. Remove the spark plug wire(s) (2, 4, and 6) from the left side spark plug(s).
3. Remove the spark plug wire(s) (2, 4, and 6) from the ignition coil.
4. Remove the spark plug wire(s) from the retaining clips.
5. Remove the spark plug wire(s) from the engine.
6. Rotate the engine for access to the rear of the engine. Refer to Rotating the Engine for Service Access.
7. Remove the spark plug wire(s) (1, 3, and/or 5) from the right side spark plug(s).
8. Remove the spark plug wire(s) (1, 3, and/or 5) from the ignition coil.
9. Remove the spark plug wire(s) from the retaining clip.