Rendezvous V6-3.5L (2007)
Important: The lock cylinder tumblers are not self-retaining. Hold the tumblers in place when the key is not in the lock cylinder. Hold
the lock cylinder tumblers (8) in place when performing this procedure.
1. Hold the cylinder (6) so that the side with 5 tumbler openings are up.
2. Insert 5 tumbler springs (7) into the 5 spring wells.
3. Install the tumbler (8) for position 4 in the slot nearest to the front of the lock cylinder.
4. Install the 3 remaining tumblers (8) for positions 6, 8 and 10 in the lock cylinder.
5. Press the tumblers into place with light hand pressure.
6. Insert the key into the lock cylinder (6). If the tumblers are not flush with the lock cylinder, remove the tumblers and perform the coding procedure
again.
Important: Hold the tumblers in place before removing the key.
7. Rotate the lock cylinder (6) so that the side with 3 tumbler openings are up.
8. Insert 3 tumbler springs (7) into the 3 spring wells.
9. Install the tumbler for position 5 into the slot nearest the front of the lock cylinder.
10. Install the 2 remaining tumblers for positions 7 and 9 in the lock cylinder.
11. Press the tumblers into place with light hand pressure.
12. Insert the key into the lock cylinder (6). If the tumblers are not flush with the lock cylinder, remove the tumblers and perform the coding procedure
again.
13. Lubricate the tumblers using GM P/N 12346241 or equivalent.
14. If necessary, perform the following steps to install the shudder door.
*
Install the 2 plate springs (3) into the 2 spring wells in the head of the lock cylinder (6).
*
Press the shutter (2) into the lock cylinder until it snaps into place.
15. Insert the key into the lock cylinder (6). If the lock cylinder does not rotate in the lock cylinder housing, disassemble the lock cylinder and perform
the coding procedure again.
16. Partially remove the lock cylinder core to install the spring and ball.
17. Place the detent spring (5) into the spring well located on the side of the lock cylinder (6).
18. Apply the heavy grease to end of spring to retain the detent ball. Carefully place the detent ball (4) on the detent spring (5).
19. Using a small flat-bladed tool to hold the ball in place. Simultaneously insert the lock cylinder core into the lock cylinder housing.
Caution: Wear safety glasses in order to avoid eye damage.
20. Depress the detent ball and spring and insert the cylinder (6) into the lock cylinder housing (9).
21. Insert the key into the lock cylinder (6). If the lock cylinder does not rotate in the lock cylinder housing, disassemble the lock cylinder and perform
the coding procedure again.
22. Install the lock pawl (10) to the lock cylinder (6).
23. Install the lock pawl E-clip (12) in order to retain the lock pawl.
24. Remove the key from the lock cylinder (5).
25. Install the lock cylinder cap (1) by pressing the cap onto the lock cylinder with light hand pressure.
Assembling and Coding the Endgate Lock Cylinder
The endgate lock cylinder uses 7 tumblers positions 3 through 9. The tumbler positions are staggered on both sides of the lock cylinder 5 on one side and
3 on the other.
