Rendezvous V6-3.5L (2007)
Body Control Module: Service and Repair
Body Control Module Replacement
Removal Procedure
Important: You must perform the new body control module (BCM) setup when replacing the BCM. Refer to Body Control Module
Programming and Setup.
1. Disconnect the negative battery cable.
2. Remove the console accessory wiring junction block.
3. Rotate the BCM retaining lever (1) to release the BCM from the console accessory wiring junction block.
4. Remove the BCM (2) from the console accessory wiring junction block.
Installation Procedure
Important: Align the BCM to the console accessory wiring junction block.
1. Install the BCM (1) onto the console accessory wiring junction block.
2. Rotate the BCM retaining lever (2) to secure the BCM to the console accessory wiring junction block.
3. Install the console accessory wiring junction block.
4. Connect the negative battery cable.
5. Perform the new BCM setup. Refer to Control Module References for programming and setup information. See: Testing and
Inspection/Programming and Relearning
