Rendezvous V6-3.5L (2007)
Air Bag: Service and Repair
Inflatable Restraint Instrument Panel Module Replacement
Inflatable Restraint Instrument Panel Module Replacement
Removal Procedure
Caution: Refer to SIR Inflator Module Handling and Storage Caution.
Caution: A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual
stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system. See: Air Bag(s) Arming and Disarming/Service and Repair
2. Remove the trim pad from the instrument panel (I/P).
3. Disconnect the inflator module connector.
4. Remove the 4 bolts from the inflator restraint module bracket.
5. Remove the inflatable restraint module from the I/P.
6. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
Installation Procedure
1. Install the inflatable restraint module to the I/P.
Notice: Refer to Fastener Notice.
2. Install the I/P bolts to the inflatable restraint module.
Tighten the bolts to 10 N.m (89 lb in).
3. Connect the inflatable module connector.
4. Install the trim pad to the I/P.
5. Enable the SIR system. See: Air Bag(s) Arming and Disarming/Service and Repair
