Rendezvous V6-3.5L (2007)
you intend to deploy the inflator module.
*
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of the inflator
module due to the force of the rapid expansion of gas inside the inflator module.
*
If you are deploying a dual stage inflator module with stage 1 already deployed, the fixture may not move and the noise may have been
reduced.
Clear the area of people.
17. Separate the 2 banana plugs on the SIR deployment harness.
18. Connect the SIR deployment harness wires to the power source. Inflator module deployment will occur when contact is made.
19. Disconnect the SIR deployment harness from the power source after the inflator module deploys.
20. If the inflator module did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group. Otherwise,
proceed to the following steps.
Caution: Refer to SIR Deployed Inflator Modules Are Hot Caution.
21. Seat one banana plug into the other in order to short the deployment harness leads.
22. Put on a pair of shop gloves.
23. Disconnect the pigtail adapter from the inflator module as soon as possible.
24. Inspect the pigtail adapter and the SIR deployment harness. Replace as needed.
25. Dispose of the deployed inflator module through normal refuse channels.
