Rendezvous V6-3.5L (2007)
Power Door Lock Switch: Service and Repair
Power Door Lock Switch Replacement
Removal Procedure
1. Remove the door trim panel.
2. Use a small flat-bladed tool to release the clips at the top and the bottom of the door lock switch.
3. Disconnect the electrical connector from the switch.
4. Remove the switch.
Installation Procedure
1. Install the door lock switch to the trim panel. Press the switch into place until fully seated.
2. Connect the electrical connector to the door lock switch.
3. Install the door trim panel.
4. Test the lock switch for proper operation.