Rendezvous V6-3.5L (2007)
13. Secure the lock cylinder in the J41340.
1. Inspect that the spring retainer is facing up and positioned directly under the punch slots.
2. Insert the lock cylinder completely into the J41340 until the lock cylinder bezel contacts the J41340.
3. Tighten the J41340 holding screw.
14. Stake the bezel end of the spring retainer:
1. Hold the flat side of the punch squarely against the face of the lock cylinder bezel.
2. Stake the lock cylinder metal over the spring retainer prong.
15. Stake the opposite end of the spring retainer:
1. Remove the J41340 punch.
2. Rotate the J41340 punch 180 degrees.
3. Hold the J41340 punch squarely against the end of the punch slot.
4. Stake the lock cylinder metal over the spring retainer prong.
16. Loosen the J41340 holding screw.
17. Remove the lock cylinder from the J41340.
18. Inspect that the spring retainer is properly staked. Repeat staking as needed.
19. Lubricate the lock cylinder retainer slot and the lock cylinder retainer with GM P/N 12345996 or equivalent.
20. Orient the lock cylinder retainer to the tapered notch in the lock cylinder housing.
21. Insert the ignition lock cylinder into the ignition lock cylinder housing.
22. Inspect for proper ignition lock cylinder rotation using the key.
Assembling and Coding the Door Lock Cylinder
The door lock cylinder uses 7 tumblers (positions 3 through 9). The tumbler positions are staggered on both sides of the lock cylinder (5 on one side and
3 on the other).
