Rendezvous V6-3.5L (2007)
8. Disconnect the power steering gear inlet pipe/hose from the routing clip.
9. Disconnect the power steering gear inlet pipe/hose fitting from the power steering gear. Discard the O-ring seal.
10. Remove the power steering gear inlet pipe/hose from the vehicle.
Installation Procedure
1. Position the power steering gear inlet pipe/hose into the vehicle.
Notice: Refer to Fastener Notice.
2. Using a NEW O-ring seal, connect the power steering gear inlet pipe/hose fitting to the power steering gear.
Tighten the power steering gear inlet pipe/hose fitting to 27 N.m (20 lb ft).
