Rendezvous V6-3.5L (2007)
2. Install the bolts which connect the strut to the knuckle. Hand tighten only.
3. Connect the front lower control arm ball stud to knuckle.
Notice: Refer to Fastener Notice.
4. Attach the ABS bracket to the steering knuckle.
Tighten the ABS bracket bolt to 10 N.m (7 lb ft).
5. Install the outer tie rod to the steering knuckle.
6. Install the front wheel drive shaft bearing.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Measure and adjust the front alignment.
