Rendezvous V6-3.5L (2007)
Pressure Regulating Solenoid: Service and Repair
Pressure Control Solenoid Replacement
Removal Procedure
1. Remove the case side cover.
2. Disconnect the transaxle wiring harness.
3. Remove the pressure control solenoid (322).
Installation Procedure
1. Install the pressure control solenoid (322).
2. Connect the transaxle wiring harness.
3. Install the case side cover.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
4. Reset the TAP values.
