Rendezvous V6-3.5L (2007)
1. Install the transmission upper brace.
Notice: Refer to Fastener Notice.
2. Install the transmission upper brace bolts.
Tighten the transmission upper brace outboard bolts (2) to 23 N.m (17 lb ft).
Tighten the transmission upper brace inboard bolt (1) to 50 N.m (37 lb ft).
3. Lower the vehicle or raise the powertrain until the frame insulators contact the chassis.
4. Install the two frame rear bolts.
5. Connect the intermediate steering shaft to the steering gear.
6. Install the transmission upper brace nut located behind the power steering pump.
Tighten the transmission upper brace nut to 50 N.m (37 lb ft).
