Rendezvous V6-3.5L (2007)
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
9. Remove and discard the wheel bearing/hub bolts.
Important: Ensure that the wheel drive shaft outer seal (boot) is not damaged.
10. Remove the wheel bearing/hub.
Installation Procedure
1. Install the wheel bearing/hub.
Notice: Refer to Fastener Notice.
2. Install NEW wheel bearing/hub bolts.
Tighten the new wheel bearing/hub bolts to 130 N.m (96 lb ft).
3. Install the brake rotor.
4. Install the wheel drive shaft nut.
Important: Ensure that the connector clip engages the bracket properly.
5. Install the wheel speed sensor electrical connector to the bracket.
