Rendezvous AWD V6-3.4L VIN E (2005)
Keyless Entry Receiver: Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the upper trim pad.
2. Disconnect the remote control door lock receiver electrical connector (1).
3. Remove the remote control door lock receiver (2) from the defroster air duct.
IMPORTANT: Disengage the remote control door lock receiver retainers and lift upward.
INSTALLATION PROCEDURE
1. Install the remote control door lock receiver (2).
IMPORTANT: Position the remote control door lock receiver to the defroster air duct.
2. Engage the remote control door lock receiver retainers.
3. Connect the remote control door lock receiver electrical connector (1).
4. Install the upper trim pad.
5. If a new remote control door lock receiver is being installed, program the transmitter. Refer to Transmitter Programming. See: Testing and
Inspection/Programming and Relearning
