Rendezvous AWD V6-3.4L VIN E (2005)
Notice: Refer to Fastener Notice in Cautions and Notices.
7. Install the screws to the front door trim panel.
Tighten the front door trim panel screws to 2 N.m (18 lb in).
8. Install the power window switch. Refer to Power Window Switch Replacement.See: Sensors and Switches/Sensors and Switches - Windows and
Glass/Power Window Switch
Trim Panel Replacement - Side Front Door (Rendezvous)
Trim Panel Replacement - Side Front Door (Rendezvous)
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Open the door.
2. Disconnect the power window switch assembly. Refer to Power Window Switch Replacement.See: Sensors and Switches/Sensors and Switches -
Windows and Glass/Power Window Switch
3. Remove the screws from the front door trim panel
4. Use the J 38778 to remove the trim panel.
1. Reposition the electrical harness connectors.
2. Remove the trim panel from the vehicle.
Installation Procedure
Important: Before installing the front door trim panel, discard the old trim panel retainers and replace with NEW trim panel retainers.
1. Install the new retainers to the front door trim panel.
2. Route the electrical connectors through the trim panel.
3. Align the trim panel to the door inner panel, guiding the door handle through the trim panel.
4. Install the upper edge of the trim panel to the top edge of the inner door panel, pressing down firmly until the trim panel is fully seated.
