Rendezvous AWD V6-3.4L VIN E (2005)
1. If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:
*
Dimension (a) is 19.5 mm (0.78 in) above the feature line on the door.
*
Dimension (b) is 68.7 mm (2.7 in) from the front edge of the door.
2. Warm the door surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the door emblem.