Rendezvous AWD V6-3.4L VIN E (2005)
Body Emblem: Service and Repair
Emblem/Nameplate Replacement - Liftgate (Aztek)
Emblem/Nameplate Replacement - Liftgate (Aztek)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem/nameplate.
1. Apply tape to the area around the liftgate emblem/nameplate.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6 in) from the surface.
Apply the heat using a circular motion for about 30 seconds.
3. Remove the emblem/nameplate from the liftgate surface using a plastic, flat-bladed tool.
4. Remove all adhesive from the liftgate surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive remover disk
3M(TM) P/N 07501 or equivalent.
5. Clean the liftgate surface using Varnish Makers and Painters (VMP) naptha.
Installation Procedure
1. Mark the tape with the measurement for the proper location of the emblem.
2. Warm the liftgate surface with a heat gun J 25070 152 mm (6 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the liftgate surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the liftgate to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the liftgate emblem.
