Rendezvous AWD V6-3.4L VIN E (2005)
Lower Side Moulding / Trim: Service and Repair
Molding Replacement - Rear Door Body Side (Rendezvous)
Molding Replacement - Rear Door Body Side (Rendezvous)
Removal Procedure
1. Open the rear door.
2. Pull the upper edge of the rear door body side molding out, to release the retainers.
Notice: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
3. A thin, plastic flat-bladed tool may be used between the door and the molding to help release the retainers.
Remove the rear door body side molding from the door.
Caution: Refer to Safety Glasses Caution in Cautions and Notices.
4. Drill a small hole into the center of the center retainer pins of the lower support retainer.
5. Install a small screw into the hole in the center retainer pin.
6. Remove the center retainer pin using small pliers and pulling out the center retainer pin.
