Rendezvous AWD V6-3.4L VIN E (2005)
Passenger Assist Handle: Service and Repair
Assist Handle and Rear Coat Hook Replacement (Rendezvous)
Assist Handle and Rear Coat Hook Replacement (Rendezvous)
Removal Procedure
1. Rotate the assist handle downward.
2. Remove the screws from the handle assembly.
3. Remove the bulb socket assembly from the lamp assembly.
4. Disconnect the electrical connectors.
5. Remove the assist handle assembly.
Installation Procedure
1. Connect the electrical connectors.
2. Install the bulb socket in the lamp assembly.
3. Position the pull handle.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the screws to the assist handle and coat hook.
Tighten the screws to 3 N.m (27 lb in).