Rendezvous AWD V6-3.4L VIN E (2005)
2. Press the module into the bracket until the module is firmly seated.
3. Connect the electrical connector to the memory seat module.
4. Install the seat cushion assembly (1) to the seat riser.
5. Install the fasteners (2) to the seat cushion assembly (1).
6. Adjust the front seat assembly up and forward in order to access the fasteners (1).
7. Install the fasteners (1) to the seat cushion assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the fasteners to 9 N.m (80 lb in).
8. Angle the front seat cushion up, in order to access the assembly fasteners.
Tighten the fasteners to 9 N.m (80 lb in).
9. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 in Restraint Systems.
10. Calibrate the seat. Refer to Memory Seat Calibration Procedure.
