Rendezvous AWD V6-3.4L VIN E (2005)
Seat Cushion: Procedures
Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench)
SEAT CUSHION OUTER TRIM PANEL REPLACEMENT - REAR SEAT (SPLIT BENCH)
REMOVAL PROCEDURE
1. Remove the screw from the rear seat cushion trim panel.
2. Remove the rear seat cushion trim panel by lifting up to release the retainer from the recliner hinge.
INSTALLATION PROCEDURE
1. Install the retainer slot on the rear seat cushion trim panel to tab on the recliner hinge.
2. Install the rear seat cushion trim panel by sliding down until the retainer slot is fully seated on the recliner hinge tab.
3. Install the screw to the rear seat cushion trim panel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the rear seat cushion trim panel screw to 2 N.m (18 lb in).
